Electrical Projects Thermostats should be matched to the heating elements and control knobs in accordance with the temperature of the element—some units have both high- and low-temperature burners.

Note: Do not overlook the steel spacers which must be installed with a replacement thermostat.

The attachment cord may require attention after long use. To replace it, first remove the drip pan, then the two porcelain wire-nut connectors and tape from the inside of the unit. Snap the strain-relief bushing out from the rear of the body and pull the cord out through the body.

CAUTION: Only porcelain wire-nuts and high-heat tape should be used when making connections inside of these units. Temperatures are high.

The top deck is serviced by removing the drip pans and the screws along the top rear edge of the back of the unit. Next remove the two indicator screws located above the control knobs. The deck is free and can be lifted clear.





Page 1 2 3 4
Home > Electrical Projects > Repairs > Table - Range

May 19, 2012