Found 105 Results for damage.Showing 31 to 40.
31.
Setting Up A Hydroponic Unit
Dusty and windy places do not favour good growth and plants will need protection by means of screens in such positions otherwise they may suffer serious
damage.
http://www.fun-home-projects.com/hobbies/hydroponics/setting_up_a_hydroponic_unit.html
32.
DC Motors
Series-field motors should never be run without a load, since the speed may rise to a point where it can
damage the motor.
http://www.fun-home-projects.com/electrical_projects/tools/dc_motors.html
33.
Bench - Type Continuity Checker
This means frequent changing of selector-switch function and range settings which can often be inconvenient and lead to meter
damage if not done carefully.
http://www.fun-home-projects.com/electrical_projects/tools/bench_type_continuity_checker.html
34.
Cleaning Solutions
Carbon tetrachloride was once a shop standby, but it is not the healthiest material to have around—prolonged inhalation of the fumes can cause liver
damage.
http://www.fun-home-projects.com/electrical_projects/tools/cleaning_solutions.html
35.
Hand - Held Dryer
Do not drop any small object into the fan chamber as the fan may throw it through the heater element and
damage it.
http://www.fun-home-projects.com/electrical_projects/repairs/hand_held_dryer.html
36.
Home Manicure Kit
Do not use a 110V series light continuity tester or
damage to low-voltage components will occur.
If the switch or deck is defective, the entire deck and switch assembly may be easily replaced by loosening two screws holding the transformer and two screws holding the connector-pin board.
http://www.fun-home-projects.com/electrical_projects/repairs/home_manicure_kit.html
37.
Waffle Irons
Replace the nuts on these terminals to prevent
damage to insulating washers. Remove the stop arm.
http://www.fun-home-projects.com/electrical_projects/repairs/waffle_irons.html
38.
Blenders
A sharp blow with a mallet on the shank of the screwdriver will loosen the coupling without
damage to the blender.
http://www.fun-home-projects.com/electrical_projects/repairs/blenders.html
39.
Vacuum Cleaners
(Caution: Allow the reel to unwind slowly to prevent
damage.) Remove the pedal pin from the housing and slide the bumper off.
http://www.fun-home-projects.com/electrical_projects/repairs/vacuum_cleaners.html
40.
Fans
Install the rear bearing bracket on the field coil, taking care not to
damage the windings. Install the field coil into the front cover, guiding the wound fields into position with the tabs of the front cover.
http://www.fun-home-projects.com/electrical_projects/repairs/fans.html
Page 1 2 3 4 5 6 7 8 9 10 11