threaded

Found 7 Results for threaded.

Showing 1 to 7.

1. How To Fix A Leaky Faucet
The flow of water is regulated by turning a handle which is attached to a threaded spindle. When the spindle is turned down, the washer or disc attached to the bottom of the spindle is pressed tightly against a smoothly finished ring or ground seal, to shut off the flow of water.
http://www.fun-home-projects.com/energy_savings/​hot_water_heater/​how_to_fix_a_leaky_faucet.html

2. Electric Light
Pull socket apart and note how the chain is threaded into it. Open or pry out the clamp holding the last bead of the chain, thread new chain into socket and place in clamp.
http://www.fun-home-projects.com/household_repairs/​e/​electric_light.html

3. How To Fasten Metal With Bolts, Rivets, Etc.
To use bolts, drill holes just slightly larger than the threaded shank. Slip on lock washers before screwing on the nuts.
http://www.fun-home-projects.com/household_repairs/​basic_methods/​how_to_fasten_metal_with_bolts_rivets_etc_.html

4. Frost - Tender Plants
An alternative is a length of chicken netting and some conifer twigs and boughs, or parts of a discarded Christmas tree, threaded through the holes in the netting, or wired to one side.
http://www.fun-home-projects.com/hobbies/​gardening/​winter_protection/​frost_tender_plants.html

5. Plan Before You Buy
Sufficient ties will be needed, made from soft wire threaded through 10 in/25 cm lengths of old garden hose. The stakes are set in the holes before planting.
http://www.fun-home-projects.com/hobbies/​gardening/​fruit_trees/​plan_before_you_buy.html

6. Carburation
The needle is a solid shaft, threaded for a short distance near the top to permit of adjustment by means of the adjusting nut, and is ground at an angle and to a point at the bottom to permit it to "seat" in the seating of the shut-off valve, and so control the passage of fuel into the float chamber.
http://www.fun-home-projects.com/household_repairs/​e/​engine_gasoline/​carburation.html

7. Tree Planting
The permanent tie which holds the tree to the stake should be made from a piece of wire about 18 in/46 cm long threaded through a 8 in/20 cm length of old hosepipe.
http://www.fun-home-projects.com/hobbies/​gardening/​ornamentals/​trees_and_evergreens/​tree_planting.html

Search Here:

Menu:
Home
Collecting
Crafts
Electrical Projects
Energy Savings
Hobbies
Home Ownership
Household Repairs