torch

Found 19 Results for torch.

Showing 11 to 19.

11. Pipe, Water - Copper
Heat pipe with torch or soldering iron and apply solder. Note.
http://www.fun-home-projects.com/household_repairs/​p/​pipe_water_copper.html

12. Pipe, Water - Steel
For a temporary repair, drain the pipe and dry fitting with a torch. Clean off rust, dirt and pipe dope.
http://www.fun-home-projects.com/household_repairs/​p/​pipe_water_steel.html

13. Flowers And Fruits
Torch Ginger (Zingiber Darceyi). Hawaiian Islands.
http://www.fun-home-projects.com/crafts/​dried_flower_arranging/​unusual_possibilities/​flowers_and_fruits.html

14. Removing Old Finish
Don't burn off the remaining finish with a torch. It's too dangerous.
http://www.fun-home-projects.com/household_repairs/​basic_methods/​how_to_paint/​removing_old_finish.html

15. Rebabbitting Bearings
Moisture in the housing may result in a minor explosion with attendant painful results, and this may be avoided by playing a blow torch over the housing to thoroughly dry it out.
http://www.fun-home-projects.com/household_repairs/​e/​engine_gasoline/​re_babbitting_bearings/​

16. Fuel Lines
Should rosin be used for the filling the tube should have a gasoline torch played up and down its length during the pouring to prevent the rosin solidifying before the tube is completely filled.
http://www.fun-home-projects.com/household_repairs/​e/​engine_gasoline/​fuel_lines.html

17. Soldering
Keep the torch well clear of the tank and make sure that the tank is vented., When large areas (apart from fuel tanks) have to be soldered the torch itself may be employed on the work, but on small work the iron alone should be used.
http://www.fun-home-projects.com/household_repairs/​e/​engine_gasoline/​re_babbitting_bearings/​soldering.html

18. Brazing
The work to be brazed should be cleaned in the vicinity of the joint, and should then be securely mounted on a hearth of firebrick or ordinary brick covered with asbestos cloth and brought to a red heat by means of a powerful gasoline blow torch and a small amount of the flux applied.
http://www.fun-home-projects.com/household_repairs/​e/​engine_gasoline/​re_babbitting_bearings/​brazing.html

19. Fitting Nuts - Bolts
Nuts that refuse to budge under the wrench may sometimes be started if they are tightened a little first Failing this, they should be well drenched with coal oil and left for a time, or should be heated by means of a torch or soldering iron.
http://www.fun-home-projects.com/household_repairs/​e/​engine_gasoline/​re_babbitting_bearings/​fitting_nuts_bolts.html


Page 1 2

Search Here:

Menu:
Home
Collecting
Crafts
Electrical Projects
Energy Savings
Hobbies
Home Ownership
Household Repairs


Related Searches:
torch ginger
propane torch